Radio tuning and detection circuit
Source: InternetPublisher:MartinFowler Keywords: Radio detector circuit demodulation multimeter Updated: 2020/12/08
Shown is the radio demodulation and detection circuit . The AM intermediate frequency signal is detected by the diode Dr after two stages of intermediate frequency amplification.
The audio signal is detected from the intermediate frequency carrier and then sent to the power amplification circuit of the subsequent stage. The demodulated and detected waveforms can be debugged
and tested with a multimeter and oscilloscope.
- The production of a crystal oscillator frequency-controlled broadband FM transmitter
- S9018 single tube super regenerative FM receiving circuit
- Wireless doorbell production
- MAX23691/Q 2000-800 MHz Dual-Band Tri-Mode Transmitter
- RXM-921/916/903/868/433-ES Series Receiver Modules
- XEl209 70~30 kHz Ultra-Low Power CMOS Transceiver
- Cordless phone transmitter circuit
- Amplification-hybrid antenna amplifier circuit
- Simple FM transmitter circuit with stable frequency
- 2km FM transmitter amateur production
- Double tuned IF amplifier circuit for radio
- IF amplification and detection circuit in AM radio
- Pocket AM radio circuit
- MF-20 multimeter AC voltage measurement circuit
- High frequency amplifier circuit for car radio
- Ceramic filter radio amplifier circuit diagram
- Integrated detection circuit diagram
- A radio that fits inside a hat
- Infrared code detection circuit
- Circuit diagram of cleverly using radio as telephone monitor