Flashing wall light control circuit
Source: InternetPublisher:张三叔 Keywords: Control circuit NAND gate BSP Updated: 2020/06/06
Shown is a simple flashing wall light control circuit . VD1, VD2, R3 and C2 in the circuit form a resistor step-down half-wave rectifier and
voltage stabilizing circuit, which can obtain 12 V DC voltage for circuit operation. The NAND gate and 2 form a multivibrator. By adjusting the RPI, its oscillation
frequency can be changed, so that the wall lamp lighting can flicker and glow to achieve a satisfactory effect.
When the circuit starts to oscillate, the output terminals of NAND gates 1 and 2 will alternately appear high and low. When the NAND gate l outputs a high level,
the trigger thyristor VS2 is turned on, and when H2 is lit, the NAND gate 2 outputs a low level , the thyristor VS1 is turned off, and the lamp H goes out.
- Build a Smart Garage Door Opener Using a Raspberry Pi
- How to Build a Touch-Based Color-Changing Plant Using Arduino
- Homemade Bluetooth controlled car using HC-05 Bluetooth module to communicate with mobile phone
- Controlling stepper motors with wireless remote control transceiver and PE-51 board
- Motor control circuit for starting and running without phase loss
- Design and production of radio remote control fan stepless speed regulator
- Design and analysis of voice control circuit
- Ultra-short wave item left behind reminder alarm
- Water supply reminder after water outage
- Simple disconnection burglar alarm
- Excellent performance household inverter power supply circuit
- Electric massager circuit
- Pulse therapy circuit
- Chicken supplementary light to increase egg production rate circuit
- Fish farming thermostatic control circuit
- Particle clogging alarm circuit of wheat seeder
- AC voltmeter
- collector amplitude modulation circuit
- ring amplitude modulation circuit
- Three primary color display circuit