Three places to control one motor
Source: InternetPublisher:supremeOne Updated: 2015/09/05
The control (operation) of one motor in two or more places is often called "multi-point control". The circuit as shown in the figure can control a motor from three locations. In the figure, ST is the start button and STP is the stop button. ST1 and STP2 are the control buttons at the first location; ST2 and STP2 are the control buttons at the second location; ST3 and STP3 are the control buttons at the third location. To achieve multi-point control, the key to circuit connection is: start buttons in parallel and stop buttons in series. Latest Control Circuits Circuits
- Servo motor pin diagram/working principle/application
- Homemade Bluetooth controlled car using HC-05 Bluetooth module to communicate with mobile phone
- What is a RADAX motor?
- Manual automatic air compressor control circuit
- Working principle of one Xipu STR soft starter controlling two motors
- Motor automatic cycle control circuit
- Methods for Eliminating Noise of Brushed DC Motors
- Temperature control circuit design and analysis
- Design and manufacture of three-phase motor protection circuit
- Motorcycle anti-theft device circuit design
Popular Circuits
- Homemade disinfectant circuit
- Multi-channel patrol detection control circuit a
- Assembly line outage monitoring circuit
- Haier KFR-25GW air conditioner control circuit schematic diagram
- Galanz rice cooker control circuit
- Range hood detection control circuit
- Small power electric heater temperature detection control circuit
- Electric heater temperature detection control circuit
- Voltage servo motor and control circuit
- Wide input range non-synchronous voltage mode control circuit
京公网安备 11010802033920号