AC and DC darkroom safety light circuit
Source: InternetPublisher:3228 Updated: 2019/08/25
This darkroom AC and DC dual-purpose lamp has a contactless automatic transfer switch function. Uses orange light-emitting diodes.
During normal power supply, AC 220 volts is rectified by bridge type of transformer, filtered by capacitor, and outputs about 4V DC (5V when no load). Because the battery voltage inside the machine is 3V, diode D is turned on, and the light-emitting diodes are powered by the rectified power supply. Since the BG emitter potential is lower than the base potential, BG is turned off, and the battery E in the machine is automatically turned off, and there is no current output. During a power outage, the BG emitter potential is higher than the base potential and is in a conductive state. Battery E supplies power to the light-emitting diode via BG. If the mains power is restored, diode D will be turned on again and BG will be automatically cut off.
Latest Control Circuits Circuits
- How to choose the right level of integration to meet motor design requirements?
- Design of an autonomous plant watering system using ATtiny85
- How to make a wheeled self-balancing robot using ultrasonic sensors
- JDB-LQ-TQ/2 motor full voltage starting circuit
- Controlling stepper motors with wireless remote control transceiver and PE-51 board
- Motor self-starting circuit
- Motor control circuit for starting and running without phase loss
- Hydraulic control circuit design and analysis
- Homemade short circuit alarm device
- Bicycle anti-theft alarm
Popular Circuits
- Homemade disinfectant circuit
- Multi-channel patrol detection control circuit a
- Assembly line outage monitoring circuit
- Haier KFR-25GW air conditioner control circuit schematic diagram
- Galanz rice cooker control circuit
- Range hood detection control circuit
- Small power electric heater temperature detection control circuit
- Electric heater temperature detection control circuit
- Voltage servo motor and control circuit
- Wide input range non-synchronous voltage mode control circuit