Simple light-emitting display logic pen circuit
Source: InternetPublisher:国民男神经 Keywords: LED power display power supply Updated: 2020/07/25
This luminescent display logic test pen is composed of only a NE555 time base integrated block and a small number of peripheral components. This kind of test pen can be used to judge the high and low signal levels and the presence or absence of pulse signals in digital circuits.
The circuit is shown in the figure below, which shows a simple light-emitting display logic pen circuit composed of a 555 time base circuit. The 555 time base integrated circuit is connected as a multivibrator. When probe A is floating, 3DG6 has no base current and is cut off. Pin 5 of the integrated circuit is at +E potential. The multivibrator circuit is suppressed and does not vibrate. Pin 3 outputs high potential and the LED is on, that is, there is light and no sound. When probe A is connected to logic "0", pin 4 of the reset terminal of the 555 circuit is forced to reset, pin 3 outputs low potential, and the LED goes out, that is, there is no light or sound. When probe A is connected to logic "1", the voltage drop at both ends of R2 causes pin 5 of the 555 circuit to deviate from the +E potential, the multivibrator is controlled to start, and pin 3 outputs an audio signal with a frequency of 1kHz, HTD The transducer emits sound and the LED lights up, that is, there is light and sound.
- Energy-saving motorcycle rectifier regulator
- Use pulse width modulation to get a precise output voltage
- Charging control circuit made by solar energy
- Adjustable regulated power supply with current limiting protection
- Car power 1.5V-12V six-speed converter
- 0.7~24V continuously adjustable current limiting power supply
- Detailed explanation of mobile phone charger circuit diagram
- Battery powered switching circuit diagram
- Multi-purpose battery constant current charger
- RF2131 optimal efficiency power amplifier circuit when powered by 4.8V power supply
- MAX8631X driving white LED circuit diagram
- Serial dynamic LED scanning circuit
- Dark activated LED flash circuit
- Ordinary optocoupler isolation circuit
- NE555 typical application circuit diagram (2)
- Circuit diagram for using an ordinary TV remote control to control switches of other home appliances such as light bulbs and fans
- 3W high power LED drive circuit diagram
- LM3914 drives 20 LED light-emitting columns circuit diagram
- SAA1064 serial I2C bus LED dynamic driver interface circuit diagram
- Fire emergency light circuit