Clamp circuit with op amp
Source: InternetPublisher:常思一二 Keywords: AC power supply and other power circuits Updated: 2021/05/10
In order to have a signal with an amplitude between 10mV and 10V voltage, this circuit is used in the AC amplifier post-stage signal voltage to wet the lowest level and then to 0V. 250µF electrolytic with C, sine wave between 3 and 10000 Hz with small distortion and clamped.
Latest Power Circuits Circuits
- Cleverly use the electronic ballast of waste energy-saving lamps as power supply transformer
- The constant current source composed of two transistors can drive high power
- Detailed explanation of 5v charger circuit diagram
- LNK304 non-isolated LED light string driver circuit
- Current/voltage conversion circuit using current converter
- Adjustable regulated power supply with current limiting protection
- Integrated regulated power supply with continuously adjustable output voltage
- LM317 regulated power supply
- Practical constant current charger-----Constant current charger
- Automatic charger made with LM3914
Popular Circuits
- Teach you a reliable new method to implement overvoltage protection for electronic signal inputs
- Vishay FRED Pt® ultra-fast recovery rectifier launched on the market
- Take stock of wonderful designs
- Automotive electronic fuel saver circuit diagram and principle
- Inventory of radio frequency interference rectification error circuits in amplifiers
- Heart rate detection circuit
- phono preamplifier
- Clamp circuit with op amp
- Zero-crossing trigger circuit design based on thyristor
- AC 220V load on-off indicator circuit schematic diagram
京公网安备 11010802033920号