Two motor delay control circuits
Source: InternetPublisher:偷熊计划 Keywords: Control circuit motor time relay AC contactor Updated: 2021/01/21
The delay time of the time relay is set to 5s. After checking that the wiring is correct, connect the main power switch QS on the platform to the start button
SB2, and the motor M1 starts running; after the delay relay KT is delayed for 5s, its moving and closing contacts are closed, and the KM2 coil is power, connect the KM2 main
circuit, and the motor MZ runs. Observe the action of the AC contactor , time relay and motor; change the delay time of the time relay
to 1Os and repeat the above operation. During the experiment, the motor M2 can be replaced by an incandescent lamp.
- Current output characteristics of brushed motor driver chips. How to increase the peak drive current?
- Build a Smart Garage Door Opener Using a Raspberry Pi
- Tutorial for building a remote-controlled Arduino Air-Boat
- Perform surgery on the speaker protection circuit
- A small improvement on the ordinary refrigerator motor starting circuit
- Manual automatic air compressor control circuit
- Starting method of asynchronous motor with external frequency-sensitive resistor
- Hydraulic control circuit design and analysis
- Bicycle anti-theft alarm
- Rolling door anti-theft device
- Electric plow control circuit
- Mobile phone camera flash control circuit
- Switching regulated power supply circuit
- Stapler control circuit
- Water dispenser double sheet control circuit
- Infrared voice control circuit
- Photoelectric output control circuit
- Capacitive AC contactor DC operation circuit a
- DC motor forward and reverse control circuit a
- Two motor delay control circuits
京公网安备 11010802033920号