Using diodes to make capacitor charging and discharging experimental circuits
Source: InternetPublisher:公子李 Keywords: diode charge and discharge Updated: 2023/11/22
1. The circuit is shown below.
2. Required components: 2 1 kΩ resistors, 1 red VD1 and 1 green VD2 light-emitting tube, 2 push button switches, 1 470μ electrolytic capacitor, 1 universal printing board, and 2 AA battery boxes.
3. Installation and experimental steps:
① Check the components according to the list.
②Install components and wire connections according to the schematic diagram.
③Connect the two battery boxes in series and connect them to the circuit.
④After the circuit is connected, press K1 first, and the red LED will light up, indicating the charging process. After releasing Kl, the power is disconnected. At this time, press K2 and the green LED will light up, indicating the discharge process.
- Make a simple AM radio with digital circuit
- Purpose and composition of amplifier circuit: low frequency voltage amplifier amplifier circuit
- An example of proportional integral circuit diagram
- Symmetrical output three-way frequency circuit (74LS109, 74LS113)
- Pulse frequency multiplier composed of gate circuit (CD4011)
- Simple and practical circuit designed using diode forward voltage drop
- Oil level indication circuit made by light emitting diode
- Class A2 single-ended parallel amplifier circuit
- PWM Class D amplifier circuit for automobiles
- 100W FET power amplifier circuit
- SKiiPPACK unit circuit
- Diode tester circuit
- Bridge rectifier circuit diagram and current reversal
- RF sniffer circuit
- Automobile electronic fuel saver circuit diagram
- Diode square rate detection circuit
- Triple voltage rectifier circuit
- Internal structure of MC1411 series Darlington current driver b
- Automatic water supply control circuit 2 for simultaneous monitoring of water tower and reservoir
- Diode, resistance and capacitance spark elimination circuitb