PADS Routing

自由达人

PADS Routing [Copy link]

After I saved the layout in PADS, I closed it and when I came back, all the wiring was gone. What's the problem?

自由达人

When I was wiring, I flipped the board over to wire it, and then flipped it back and all the wires were gone. What is the problem? I just started using this software.

自由达人

When I was wiring, I flipped the board over to wire it, and then flipped it back and all the wires were gone. What is the problem? I just started using this software.

qwqwqw2088

All wiring is gone. This is not a save problem. Check if there is a problem with the "reverse flip board" operation.

ienglgge

Freedom Master published on 2018-7-29 15:52 When wiring, flip the board to wire, then flip it back and all the wires are gone. What is the problem? I just started using this software

Flip it back and all the wires are gone. Do not flip it and wire it. See what the result is.

自由达人

ienglgge posted on 2018-7-30 09:28 If you flip it back, all the wires will be gone. Do not flip it and continue wiring. See what the result is.

Yes, it should be solved. It is OK to not flip the wiring. It seems that this software cannot flip the wiring; it can only be wired layer by layer. Thank you

qwqwqw2088

Freedom Master published on 2018-7-31 10:44 Yes, it should be solved. It is OK without flipping the wiring. It seems that this software cannot flip the wiring; it can only be wired layer by layer. Thank you

Other software are the same, they all wire layer by layer. Automatic wiring is another matter

自由达人

qwqwqw2088 posted on 2018-8-2 08:22 Other software are the same, they all route layer by layer, automatic routing is another matter

I originally wanted a two-layer board, and I turned it over to make it look better, but it didn't work, the wires were gone after flipping it.