[CH246 & CH241 Wireless Charging Kit Review] Part 2: Wireless Camera Transformation

wangerxian

[CH246 & CH241 Wireless Charging Kit Review] Part 2: Wireless Camera Transformation [Copy link]

1. Introduction

In the previous article, I tested the development board directly powered by the wireless charging module. The wireless camera can work normally. However, it is not reasonable to use a USB cable to connect the development board. This article continues the modification.

2. Transformation

Since there is no suitable adhesive tool at home, I directly use tape to stick the wireless charging module. The effect after sticking is shown in Figure 1 below.

Figure 1

It doesn’t look very pretty, but it’s usable and the front is still the same as before.

Figure 2

Then let's test whether it can work normally. Put the development board directly on the antenna of the wireless charging transmitter. From Figure 3 below, you can see that the LED light is on normally and the development board is working normally.

Figure 3

Let's run another routine with a screen and cover the wireless sending module with paper, as shown in Figure 4 below. The screen can also work normally.

Figure 4

3. Summary

Wireless charging modules can be applied to many scenarios. My design is just the tip of the iceberg. You can imagine using wireless power modules in different application scenarios. This is the end of the wireless camera review.