[AD21] How to solve the error Board Clearance Constraint

我本将心向明月

[AD21] How to solve the error Board Clearance Constraint [Copy link]

As the title shows, as shown in the figure below: When the PCB is checking the rules, it prompts Board Clearance Constraint (Gap=0mil) (All)

Please explain why. It should be that the distance of copper coating is wrong.

okhxyyo

From your PCB diagram, it seems that your copper coating is directly coated to the edge, with no distance, but the minimum spacing is set to 30mil in the rules below, so change the copper coating rules and re-coat the copper.

我本将心向明月

okhxyyo posted on 2021-3-31 17:43 From your PCB diagram, it seems that your copper is directly covered to the edge, with no distance, but the minimum spacing is set to 30mil in the rules below...

As shown in the figure below, the distance from the edge of my board to the copper is 30mil, which is consistent with the settings. But there is still an error below. I don't know what the prompt "out of board" means.

okhxyyo

Please find this rule in

rule settings, see how it is set here, and then change it. See if this problem still occurs.

btty038

It should be that the chamfer and line setting rules cannot be 30MIL. There is a conflict with the global. Can you set one more rule to set the priority? Can you try it?

qwqwqw2088

Need to modify the safety distance