[AD21] How to add value parameters when drawing schematic packages

我本将心向明月

[AD21] How to add value parameters when drawing schematic packages [Copy link]

As the title and picture show, when drawing a schematic package, some parameters are usually filled in. However, in AD21, it seems that the value parameter is not easy to call out and fill in. As shown in the figure below, how do I add the value parameter?

PS: Regarding the value of components, such as the size of resistors, should 1K be filled in the comment or value ? Is there a clear requirement for this, or is it just up to personal preference? I feel that this discussion is like the question of whether the outer frame of the board should use the mechanical layer or the keepout layer, which is a historical issue. I hope someone with knowledge can give an answer. Thank you~

我本将心向明月

Actually, I posted this post to ask two questions. I don’t know if the above description is clear.

1. How to retrieve the value, because the default attributes that can be filled in AD21 do not directly retrieve the value.

2. Resistor size, should 1K be filled in the comment or value?

qwqwqw2088

Comment Fill in 1K

qwqwqw2088

I don't know about version 21, but for other lower versions, just ADD in parameters.

Fill in the value of resistors and capacitors, the exported BOM is classified by balue

well_kim

Not using this version