AD19, same rules, automatic routing is ok, manual routing will be short circuit and un-roated, what is the reason?

oyhprince

AD19, same rules, automatic routing is ok, manual routing will be short circuit and un-roated, what is the reason? [Copy link]

RT!, Software: Altium Designer 19.1.6

The schematic diagram is as follows:

The automatic wiring is as follows:

Manual wiring is as follows:

oyhprince

Reports

okhxyyo

There may be a short line in the line. Or you may not connect to the center point when connecting. Try more to see if there are small line segments.

qwqwqw2088

Nothing strange

In my own software, the rules used for automatic wiring and manual wiring are different

Check the manual wiring settings, safety distance and short circuit settings

clearance constraint

short-circuit constraint

oyhprince

qwqwqw2088 posted on 2020-6-29 07:45 There is nothing strange. In my own software, the rules used for automatic wiring and manual wiring are different. Check the settings of manual wiring, safety distance and...

Are the rules for automatic wiring different from those for manual wiring?

Where are the automatic and manual routing rules?

oyhprince

qwqwqw2088 posted on 2020-6-29 07:45 There is nothing strange. In my own software, the rules used for automatic wiring and manual wiring are different. Check the settings of manual wiring, safety distance and...

Are the rules for automatic wiring different from those for manual wiring?

Where are the automatic and manual routing rules?

qwqwqw2088

oyhprince posted on 2020-6-29 11:21 Are the rules for automatic wiring different from those for manual wiring? Automatic and manual wiring...

Judging from the pictures on the first floor, the two rules are different.

Shortcut key DR setting

Ejack1979

You cannot use the shortcut keys [P][L] (Place Line) for routing. You must use [P][I] (Place >> Interactive Routing) for interactive routing.

The lines placed by the former will not automatically generate electrical properties. The latter will obtain network properties from the intersecting objects and check according to electrical rules.

轩辕默殇

I think you used the wrong line when you drew it manually.

轩辕默殇

Are you sure you are using the thread from the sixth icon?

oyhprince

Thank you for your guidance