oyhprince

qwqwqw2088 posted on 2020-6-23 07:33 Open the PCB project, open ".PcbDoc", find the Properties panel on the right, drop down the Properties panel, and click Reports...

Many thanks

oyhprince

qwqwqw2088 posted on 2020-6-23 07:26 PCB blank area, F11, Properties tab, Board Information,,,,

Reports are finally available

If un-routed reports an error, which item in reports should I look at?

qwqwqw2088

oyhprince posted on 2020-6-24 00:13 The reports are finally available. Which item in reports should I check if the un-routed report is wrong?

Check the box above

Then click Report below

See if 100%

qwqwqw2088

The situation of the OP is probably not 100%

Not 100%

In the Panels in the lower right corner, select PCB.

ALL Nets,
check the unrouted column
to see which network is not routed