SensorTile.box_--Unicleo-GUI debugging tutorial

ðÏÕÎäÕß

SensorTile.box_--Unicleo-GUI debugging tutorial [Copy link]

 

The tutorial is simple and crude, with pictures throughout.

Get a JTAG downloader and connect it as follows:

Open the STM32 ST-Link Utility to identify the chip signal. If it cannot be identified, check the cable connected to the JTAG.

Open the eDataLogxtended.bin file

The download is successful as shown below:

There was a problem identifying the serial port. Later, I found the STM32 virtual serial port software on the Internet and solved it.

Open the Unicleo-GUI software, you can identify the virtual serial port COM36 above, and after connecting, it is as follows:

Enable the sensor, click START to start receiving data through the serial port, and open the image display interface as shown below;

This is the real-time data received by the serial port:

The overall experience is good, but the Bluetooth function is not turned on.

Keep up the good work next time.

littleshrimp

How much did you pay for the downloader? Did you open it and see

tinnu

Is there any schematic diagram of the adapter board?

If it is not connected to the 40p jtab port, you have to test the pins one by one...

Jyu

SensorTile.box schematic diagram, 1 pin to 1 pin

xy12254

Where is this burning file downloaded?