iTOP-4418 development board TF card burning-boot uboot

塔7呃

iTOP-4418 development board TF card burning-boot uboot [Copy link]

Connect the TF card to the development board, set the DIP switch to TF card boot, and enter the uboot mode, as shown in the figure below.

As shown in the figure below, use the command "fastboot" and then you can burn eMMC via OTG. For specific burning methods, refer to "Section 4.1". Here, uboot in the TF card is used to boot 4418, and then fastboot can be used for burning. If you do not use fastboot at all, you can refer to the next section TF card burning Android and Qt.

Finally, please note that after the burning is completed, you need to set the corresponding uboot parameters, set the DIP switch to uboot startup, unplug the TF card, and restart the computer. The development board can then run normally.