Xunwei-IMX6Q development board Qt Creator compiles ARM architecture program

砂舞的玩笑

Xunwei-IMX6Q development board Qt Creator compiles ARM architecture program [Copy link]

In addition to compiling the program to run on the Xunwei iTOP-iMX6 development board through the command line operation in Section 11.2.2, you can also
set it directly on qtcreator, and then each compiled program can run on the development board.
As shown in the figure below, open qtcreater and operate as shown in the figure below.

Add the GCC compiler, as shown in the figure below.

Add the compiler path and click apply as shown in the figure below .

Select the Qt version, as shown in the figure below.

Select the qmake path of qt4.7.1 and click apply, as shown in the figure below.

Select the build kit, as shown in the figure below.

Configure QT4.7.1 information, as shown in the figure below.

The configuration is complete. The following is an example. Create a new project and select Qt4.7.1 as shown below.

If the compilation prompts Failed to start program. Path or permissions wrong?, just ignore it.
(, downloads: 0)

上传

点击文件名下载附件

Click Run on the interface to start compiling. The generated executable file is ARM architecture and can be directly copied to the development board for operation
.

阿德17636

I learned a lot thanks for sharing

砂舞的玩笑

Ade17636 posted on 2020-1-2 11:07 I have learned a lot, thank you for sharing