How to set device diagram symbols to be read-only in AD schematics

shaorc

In the hierarchical schematic design of AD2018, for example, if the power supply schematic is regarded as a submodule, according to the method in Figure 1, the target schematic can be abstracted into a module, and the effect is shown in Figure 2. Figure 1 Figure 2 At this time, Figure 2 can be modified by clicking on it, but I want to set Figure 2 to the effect of Figure 3 (Figure 3 is an example diagram, and the naming and port signal names inside are not important), that is, the schematic can only be read when clicking in, and cannot be modified (there is a read only watermark inside). How to set it? I have checked some information and only know that I first set it through place→ device sheet symbol. How to operate later? Please teach me Figure 3

lingking

It is recommended not to use this method, as the bit numbering is inconvenient. If you are afraid of accidental modification of a mature circuit, you can set the file attribute to read-only mode directly after programming the bit number, which can also prevent modification.

qwqwqw2088

1. There is only one main schematic diagram or top-level diagram in hierarchical schematic design, and the rest are sub-diagrams. 2. To make Figure 2 look like Figure 3, you need to add a watermark to the schematic diagram. The specific method has been discussed in the forum and can be found for reference

qwqwqw2088

There is an only read in the module reuse of Altium Designer that cannot be solved https://en.eeworld.com/bbs/thread-475179-1-1.html

a838899

MOKUAIHUA