DSP emulator driver installation error caused by the error and processing

灞波儿奔

DSP emulator driver installation error caused by the error and processing [Copy link]

I am using the Hezhongda 510 emulator. After installing the emulator driver, I can use the usb20emurst.exe included in the driver installation package to reset the emulator. However, after running CCS3.3, the following error will be reported when connecting to the development board. Error connecting to the target: Error 0x80000240/-172 Fatal Error during: Initialization, OCS, This error was generated by TI's USCIF driver. SC_ERR_REG_DETECT_SPRT <-172> The wrong support-logic address value has been used. A controller cannot be detected even though the selected port does match the hardware configuration. The standard 560 ports are 0x0, 0x1, 0x2 and 0x3. The standard EVM ports are 0x0, 0x1, 0x2 and 0x3. The standard DSK ports are 0x378, 0x278 and 0x3BC. The standard 510 ports are 0x 240, 0x280, 0x320 and 0x340. I/O Port = 240 Board Name: C64xx SEEDXDS510USB Emulator Cpu Name: TMS320C6400_0 Abort: Close Code Composer Studio. Retry: Try to connect to the target again. Cancel: Remain disconnected from the target Diagnostic: Run diagnostic utility. Select "retry" and the following error message appears[ /color] Error connecting to the target: Error 0x80002240/-121 Fatal Error during: Initialization, OCS, Control, This error was generated by TI's USCIF driver. SC_ERR_CMD_HANDLE <-121> A bad controller handle has been given to a function, either before attempting to open the controller, or after having opened the controller and ignored its error status. Valid controller handles are generated when attempts to open the controller return a clean error status. I/O Port = 240 Board Name: C64xx SEEDXDS510USB Emulator Cpu Name: TMS320C6400_0 Abort: Close Code Composer Studio. Retry: Try to connect to the target again. Cancel: Remain disconnected from the target Diagnostic: Run diagnostic utility. This situation usually occurs when the emulator driver is not installed properly. You can check the "xdsfast3.dll" file in the "..CCStudio_v3.3\cc\bin" path. If the file is 160K in size, the driver is not installed properly. If this problem occurs, even reinstalling the driver often does not succeed. You need to delete the "xdsfast3.dll" file, then disconnect the PC and the emulator, and reinstall the emulator driver. After installation, check the file size of "xdsfast3.dll" to 352K, which means the driver has been successfully installed.