This post was last edited by weiwei4 on 2019-1-21 11:49 Rapid IoT Studio online IDE This is quite easy to use. You can program without typing code. How to start? Why not turn on a lamp first!
Start with simple learning. The IDE website is as follows: https://rapid-iot-studio.nxp.com
After logging in to the website, click on the position 1 in the figure to open the project directory. Click EXAPLES to see the official example project file. Select the Control LED with APP over BLE project and open the following interface
Click the BLE icon, and the properties of the corresponding control are displayed on the right. Pay attention to the UUID item. It is the same as the UUID on the APPLICATION page. This should be the ID used for BLE communication.
The properties of another control are as shown above. Let's take a look at the APPLICATION page
You can see that there are three controls, Control 1 is a button, Control 2 is a text display label, and Control 3 is the control for Bluetooth communication. The above picture shows the control properties of the button
The above picture shows the properties of Control 2
The above picture shows the properties of Bluetooth communication for Control 3. The properties of the UUID column are the same as the properties of the BLE control on the IOT kit side. Since this example does not have Cloud communication, all the project controls are as described above. Then start compiling the project for testing. Click the hammer icon
in the picture below to compile and wait for the compilation to complete. After completion, you can download the bin program file
The above picture shows the display page of the program source code and the option to download the project file
Click the above picture to download the bin program file. The burning method is to press and hold the button on the upper left side of the kit, and press the reset button with the included tool. After the reset is completed, a U disk will be displayed on the computer. Copy the bin file into the U disk to successfully burn it into the chip. Open the mobile phone APP program and search for the kit BLE in the way of adding a new device. After the device is added, you will enter the following interface
Click the button position to control the red LED on and off
提升卡
变色卡
千斤顶