aytwartoofyoroo

NV706272R2DBDQGEVB: LIN ST Driver Stall SS Demonstration Evaluation Board

Overview

The NCV70627 is a single-chip micro-stepping motor driver with position controller and control/diagnostic interface. It is ready build dedicated mechatronics solutions connected remotely with LIN master.The chip receives positioning instructions through the bus and subsequently drives the motor coils to the desired position. The onchip position controller is configurable (OTP or RAM) for different motor types, positioning ranges and parameters for speed, acceleration and deceleration. The NCV70627 acts as a slave on LIN bus and the master can fetch specific status information like actual position, error flags, etc. from each individual slave node.Note: This board must be used with the NCV706278FULLGEVK.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-14 23:45:57

ADXL345 sensor acceleration detection in vibration environment
I am now using the adxl345 sensor to detect bicycle brakes. The X-axis is used to detect speed changes and the brakes can be very sensitive, but when the bumps are too small, they are mistakenly judge
Contactless facial recognition access control system
[i=s]This post was last edited by manhuami2007 on 2022-10-23 10:14[/i]Contactless facial recognition access control system 1. Introduction In the epidemic environment, people don’t want to touch thing
Basic knowledge of NFC architecture and standards involved
NFC technology evolved from contactless radio frequency identification (RFID). The transmission range of RFID can reach several meters or even tens of meters, and it can only read and judge informatio
[Perf-V Evaluation] Exception (interrupt) handling of Hummingbird E203
The entry.S in sirv-e-sdk is related to exceptions (interrupts). To use the interrupt function, you must understand how to write an interrupt handler. The main contents of entry.S are as follows: #inc
Calculation and setting of baud rate of msp430 microcontroller
By setting three baud rate-related registers, namely the baud rate integer UxBR1, UxBR0, and the baud rate trim register UxMCTL, the baud rate control parameters are calculated using the following for
RSL10 rich board set!
RSL10 rich board set! After waiting for dozens of days, I finally received the event board, it’s very rich! 1. RSL10 QFN EVB V1.3 minimum system + J LINK Bringing out the GPIO port makes it very conve

Datasheet More

Circuits More