sigma

NCP1094GEVB: PoE-PD Interface Controller Evaluation Board

Overview

The NCP1093 and NCP1094 are members of ON Semiconductor's high power HIPO Power over Ethernet Powered Device (PoE-PD) product family and integrate an IEEE802.3at PoE-PD interface controller. Both Variants incorporate the required functions such as detection, classification, under voltage lockout, inrush and operational current limit. A power good and NCLASS_AT signal have been added to guarantee proper control of the DC-DC converter for both type-I and type-II operation. In addition, the NCP1093 offers programmable under voltage lockout while the NCP1094 provides an auxiliary pin for applications supporting auxiliary supplies. The NCP1093 and NCP1094 are fabricated in a robust high voltage process and integrate a rugged vertical N-channel DMOS suitable for the most demanding environments and is capable of withstanding harsh environments such as hot swap and cable ESD events. The NCP1093 and NCP1094 complement ON Semiconductor's ASSP portfolio in industrial devices and can be combined with stepper motor drivers, CAN bus drivers, and other high-voltage interfacing devices to offer complete solutions to the industrial and security market.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-24 21:05:37

Pull-up Resistors Summary
[size=5][color=rgb(62, 62, 62)]1. When the TTL circuit drives the COMS circuit, if the high level output by the TTL circuit is lower than the lowest high level of the COMS circuit (usually 3.5V), then
Has anyone used LT3751 to boost 400V?
The above picture is a screenshot of the PDF. I have never used it. Recently there is a demand for a voltage output of 450V15mA Come and ask
[Voice and vision module based on ESP32S3] Hardware design, debugging and progress-serial port circuit-2
In the ESP32OpenMV project, the original plan was to use CP2102 as the serial-to-USB chip design, but when purchasing, I found that this previously cheap chip had become a bit expensive, so in order t
rfeasylinkRx initialization problem solved
I am using the CC1310F128RSM board. When initializing rfeasylinkrx, the initialization fails. The problem is as follows; #ifdef RFEASYLINKRX_ASYNC/* Reset the timeout flag */rxTimeoutFlag = false;/* S
I would like to ask about some small applications of op amps.
I have marked the specific small problems on the picture...This is the circuit diagram simulated by Multisim, which is similar to the result of the physical test. I am not good at analog electronics,
This mini motorcycle is so cool!
Abstract : You must have seen a lot of balancing cars, such as the most famous one is the bicycle balancing car made by the wild iron man Zhihui . That thing is too advanced for ordinary people to mak

Datasheet More

Circuits More