aerobotics

NCL30082SMRTGEVB: 8 W SEPIC LED Driver Evaluation Board

Overview

The NCL30082SMRTGEVB is designed to effectively evaluate the NCL30082, which is a PWM current mode controller targeting isolated flyback and non-isolated buck-boost constant current topologies. The controller operates in a quasi-resonant mode to provide high efficiency. Thanks to a novel control method, the device is able to precisely regulate a constant LED current from the primary side. This removes the need for secondary side feedback circuitry, biasing and an optocoupler. The device is highly integrated with a minimum number of external components. A robust suite of safety protection is built in to simplify the design. The device supports analog/digital dimming and thermal foldback.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-22 13:50:02

TI op amp stability analysis
MSP430F5438 Evaluation Board
I'm about to graduate from university, and I can't use my graduation project, so I'm going to make a board that I can't play with. I can also use an ESP32 board to replace it. Hehehe, my graduation pr
Servo Motor Driver Problems
Our company uses a servo motor driver in its testing machine products. But there is a problem, that is, the encoder has pulse output when the motor is not rotating. According to the manual, the freque
[Mil MYD-YA15XC-T Review] + Using QT to read temperature and humidity sensor data
[i=s]This post was last edited by Popular Technology on 2021-12-21 08:50[/i]Mier MYC151 usage report + temperature and humidityThis time, based on the previous oled , we tested the temperature and hum
Question about freewheeling diode
The current of a single relay is 0.6A. Is it better to connect it as shown in Figure 1 or Figure 2?Figure 2
[Recruitment] [Recruitment] Full-time and part-time are both available
A chip technology company in Beijing is recruiting ( chip design engineer)Job description:1. Responsible for the design of RF, microwave, and millimeter wave integrated circuit chips; 2. Responsible f

Datasheet More

Circuits More