I bought an ESP32 development board before, and I wanted to find out if there was an expansion board for this board in Kaiyuan Plaza. After all, it would be too ugly to just use Dupont cables to connect it. After searching for a long time and finding nothing suitable, I made one myself. In order to reduce the difficulty of re-engraving this board, no patches are added. Just solder a pin header and a female header and it can be used directly. This board also reserves a lot of space. If necessary, you can add some LEDs and resistors yourself, so that the high and low levels of the GPIO are more direct. Regarding display, the 0.96-inch OLED can already meet most needs, but for special needs, a 240x2401.3-inch TFT is also connected. There is also a lot of space reserved on the back, and you can modify it yourself to add a TF card slot and camera pin header.
All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.
It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.
Supported by EEWorld Datasheet