他们逼我做卧底

Multi-Signal Generator (2019)

Overview

Multi-signal generator (2019), the project contains some sub-circuits and the overall circuit, the output is 1. A continuously adjustable square wave pulse signal with a frequency of 1%kHz~2kHz, the amplitude is not less than 3.2V 2. The same frequency as the square wave Sine wave signal, the output voltage distortion is not greater than 5%, and the peak-to-peak value (vpp) is not less than 1V. 3. A narrow pulse signal with a continuously adjustable duty cycle of 5%~15% at the same frequency as the square wave, and the amplitude is not less than 3.2V. 4. The phase error of the cosine wave signal that is orthogonal to the sine wave is not greater than 5°. The output voltage peak-to-peak value (Vpp) is not less than 1V. Each signal output must be connected to an IkΩ load resistor. The engineering is defective and will be continuously modified and improved.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-22 14:32:04

Comparison of three RC oscillator circuits
[size=4](1) The RC oscillator circuit has a simple structure, is easy to adjust, and is economical and reliable. [/size] [size=4] [/size] [size=4](2) The oscillation frequency of the RC oscillator cir
ADS2021 analog circuit design, encountered problems
How to analyze S parameters when using ADS2021 for bandpass filter design?
00-59 seconds timer (use software delay)
1. Experimental Task 　　As shown in the figure above, two common cathode digital tubes are connected to the P0 and P2 ports of the AT89S51 microcontroller respectively. The P0 port drives the tens digi
[Evaluation of EC-01F-Kit, the NB-IoT development board of Anxinke] 04. Debug EC-01F with the serial port assistant and connect to Alibaba Cloud via MQTT
[i=s]This post was last edited by Li Baiyi on 2021-12-22 21:11[/i]1 Test baud rate AT 2 Turn off echo ATE0 3 Check whether the SIM card is normal. If it returns to normal, go to the next step AT+ECICC
Roulette Circuit
Create a rotating LED using the classic 555. When the switch is pressed, the LED rotates very fast. After the switch is released, the rotation gradually slows down and eventually stops.From: http://ww
[Fudan Micro FM33LC046N] The second PACK solves the JLINK problem but there is another problem?
Finally I made up my mind to download MDK530, and finally solved the problem that the PACK package could not be installed.I tried installing 5.1 MDK on two computers but failed. This just gave me a re

Datasheet More

Circuits More