他们逼我做卧底

cricket system controller

Overview

This project is a cricket control system using a resistive screen. The project features are:

1. The main control is STM32F103C8T6

2. The four-wire resistive screen driver adopts H2046 (can replace XPT2046)

3. JDY23 Bluetooth module (slave)

4. 0.96-inch OLED display, refer to Jixiaoxin OLED display module-0.96-inch (7PIN) - Lichuang EDA open source hardware platform (oshwhub.com)

5. The GUI uses mini open source GUI - ugui. For usage methods, please refer to the blog mini open source GUI - uGUI for quick use . It is an open source GUI that is very suitable for OLED.

6. Provide a simple PID test program, on which your own control algorithm can be added.

7. The circuit includes the minimum system, battery voltage AD sampling, buzzer driver, OLED driver, servo driver, serial port, resistive screen driver, Bluetooth module and power system.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-18 01:53:58

[MM32 eMiniBoard Review] Using MM32-LINK under IAR
The eMiniBoard integrates the MM32-LINK emulator. Normally, after installing the corresponding support package, you can find the MM32-LINK option in the MDK project settings.However, unlike MDK, the c
BQ76940 cannot be powered off
I'm using BQ76940 now. I disconnected the highest level and found that the chip still has power, and the 3.3 of the chip is still there, and the I2C communication is also normal. I would like to ask t
Application of 12-bit D/A converter MAX531 in high-frequency switching rectifier module
introductionThe DZW02 220V series rectifier modules developed by our company are widely used in power supply systems. Through full-bridge phase-shift high-frequency conversion and the use of high-qual
17 kinds of component PCB packaging illustrations, beautiful
Source: Breadboard Community The construction of component packages is an important part of PCB design. A small mistake may cause the entire board to not work and cause serious delays in the construct
Three-port DC-DC converter (Problem C)
Parts information management system Musecad CircuiteXpert - solves parts usage, library management, auditing, plug-in failure, BOM...
[i=s]This post was last edited by musecad on 2020-8-15 12:05[/i]As a long-established schematic design tool, Capture is powerful and easy to use, and is the first choice for many RDs. Here we introduc

Datasheet More

Circuits More