[Shanghai Hangxin ACM32F070 development board + touch function evaluation board evaluation] MDK development environment test LCD Demo

KING_阿飞

[Shanghai Hangxin ACM32F070 development board + touch function evaluation board evaluation] MDK development environment test LCD Demo [Copy link]

 

[Shanghai Hangxin ACM32F070 development board + touch function evaluation board evaluation] MDK development environment test LCD Demo

We first download the official information to test whether the board is normal. Download address: [New reminder] Hangxin information - F070 development board & Touch board introduction, LCD board schematic diagram - Domestic chip exchange - Electronic Engineering World - Forum (eeworld.com.cn)

First, we open the firmware library\firmware library and install Aisinochip.ACM32F0X0.1.0.1.pack, and then we can use MDK for development.

To test whether the LCD functions normally, we download the LCD routine package, LCD_TK.

After opening the project, we open the magic wand tool, modify the chip, download and use CMSIS-DAP

After the first download, I found that my LCD screen did not light up, and the multimeter was normal. After I unplugged the LCD and plugged it back in, the LCD finally lit up. It should be caused by a bad connection.

The following is a successful test image:

wangerxian

Support Keil development, it is quick to get started! Looking forward to the in-depth evaluation later!

KING_阿飞

wangerxian posted on 2022-9-26 17:44 Support Keil development, it is relatively fast to get started! Looking forward to the in-depth evaluation later!

really