It introduces the basic operation of the software, schematic design, CAE packaging, LAYOUT PCB design and PADS_ROUTER router. It also introduces quite a few design examples. Everyone is welcome to watch!
What do the specific state values of the FSMSTATE state machine mean? The data sheet does not explain it in detail, and I can't find any information about it on the Internet.
[i=s] This post was last edited by qq849682862 on 2014-11-4 08:23 [/i] First, refer to the UserManual to burn the boot program. Note that as shown in the figure, the address should be changed to 08000
For cost control reasons, I initially planned to use a finished case. I looked for several case factories and initially selected one. The case and panel are both made of aluminum alloy.
I drew a 3D re
Why does the program freeze when it enters the wait mode? I commented out the wait mode in the program and everything works fine. What is the difference between configuring wait mode and Low power wai
[p=32, null, left][font=微软雅黑][size=14px]1. Introduction to TouchGFXDesigner[/size][/font][/p][p=32, null, left][font=微软雅黑][size=14px] GFX is a library that runs very high on MCU and can be seen in var
I'll say this in advance: I missed TI's promotion and couldn't help but buy a launchxl-f28379d. I got it the day before yesterday. Today, I'm itching to take some time to light it up. Here are two unb