Training

Location:Training / Tools/EDA / Simulation / Use Atmel Studio 6 to fine-tune your QTouch design for optimal performance / Use Atmel Studio 6 to fine-tune your QTouch design for optimal performance

Chapter 1：Use Atmel Studio 6 to fine-tune your QTouch design for optimal performance

Duration：7 minutes and 18 seconds
Date：2015/02/26

Uploader：dongcuipin

Introduction

keywords： Atmel Qtouch Studio 6

This video teaches you how to fine-tune your QTouch design to achieve optimal performance through Tuning WizardT in Atmel Studio 6 .

You Might Like

Recommended Posts

Announcement of postponement of the award for the Pingtouge RVB2601 open source application creative collection activity: Hi, friends who participated in the eventThe Pingtouge RVB2601 open source application creative collection activity was originally scheduled to announce the award results before June 22, but it is now; EEWORLD社区 XuanTie RISC-V Activity Zone

Q&A on Connectivity with Qorvo: Addressing Thermal Challenges at the Wi-Fi Front End: Q: What Wi-Fi thermal challenges are RF front-end designers facing?A: We see two main design challenges.The first challenge is the increasing market demand for smaller, thinner, more stylish routers,; Jacktang RF/Wirelessly

The impact of common mode noise on EMI: [i=s]This post was last edited by Aguilera on 2019-7-21 22:38[/i]Most conducted EMI problems are caused by common-mode noise. And, most common-mode noise problems are caused by parasitic capacitance i; Aguilera Analogue and Mixed Signal

EEWORLD University - Introduction to brushed DC motors and basics of H-bridge drive circuits: Introduction to brushed DC motors and basic H-bridge drive circuits : https://training.eeworld.com.cn/course/3896; hi5 Analog electronics

My thoughts after reading the good book "Electronic Engineer Self-study Handbook": I was fortunate to get the book "Self-Study Handbook for Electronic Engineers" by Mr. Cai Xingshan published by the Publishing House of Electronics Industry. After receiving the book, I found it to be; za321456 Analog electronics

Why is the power supply voltage pulled down from 12V to more than 3V when using lm2596 to stabilize 5V?: [color=#333333]Using lm2596 to stabilize 5V, why is the power supply voltage pulled down from 12V to more than 3V? The small light bulb cannot light up and cannot output 5V[/color]; 峰江大闪电 Power technology

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号