Training

Location:Training / Testing and Measurement / How to use modern oscilloscopes to achieve accurate measurements (2) / How to use modern oscilloscopes to achieve accurate measurements (2)

Chapter 1：How to use modern oscilloscopes to achieve accurate measurements (2)

Duration：7 minutes and 45 seconds
Date：2013/05/03

Uploader：dongcuipin

Introduction

keywords： Oscilloscope Rohde & Schwarz

How to use modern oscilloscopes to achieve accurate measurements, six principles for accurate measurements: minimize quantization error, always pay attention to the sampling rate, choose the appropriate bandwidth, capture the full picture of the signal to be measured, reduce the influence of the probe, different measurement methods, and post-processing application

You Might Like

Recommended Posts

Introduction to Common Communication Types in the Internet of Things: Common communication types in the field of Internet of Things include wired communications as follows: RS485: two-wire system, differential signal transmission, half-duplex communication, and a maximu; 蓝先生 RF/Wirelessly

D3DM vs OpenGL ES: Recently, I checked the information of both. I found that OpenGL ES is very popular because it supports many platforms and has good versatility. Of course, the performance is also very good. I wrote a; zhugjbest Embedded System

I'm risking my life to ask if anyone has the vxworks touch screen driver code?: Recently, my teacher asked me to develop a touch screen driver under vxworks on an arm9 board. I wonder if anyone has the relevant driver code for reference! It doesn't matter how much it is! Or if an; ninyxth Real-time operating system RTOS

How to achieve 8 times frequency in ISE: The input clock is 36.15MHz. I want to generate a clock of 36.15*8=289.2Mhz. How can I achieve this in ISE?; 撼地神牛 FPGA/CPLD

KL27miniBoard Issues: I got a FreeLink+KL27miniBoard, the picture is as follows, but there is no information. Can anyone share the information? Thank you!; chenbingjy NXP MCU

Security fuse ××own appears again, so frustrating: When I use the JTAG tool on my F149, the Security fuse ××own appears again. I am so depressed.This is the most frightening thing when making F149.Basically, a whole chip has to be scrapped.I am so dep; wxssyau Microcontroller MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号