• Duration:37 minutes and 48 seconds
  • Date:2024/09/28
  • Uploader:宋元浩
Introduction
keywords: RISC-V
The RSC-V architecture has attracted great attention from the industry in a very short period of time. From many
small companies that react quickly to powerful giant companies (such as Alibaba, Huawei, etc.), they have all begun
to use the RISC-V architecture to develop products. Especially in the field of embedded Internet of Things, whether
it is the hardware processor core or the software tool chain, the RSC-V architecture processor has the ability
to replace traditional commercial embedded processors (such as ARM Cortex-M processors)
. This course will teach RSC-V embedded system development step by step, and
quickly master the strongest free open source architecture in actual combat!
Unfold ↓

You Might Like

Recommended Posts

I2C interface problem of PIC16F877A
I want to use a PIC16F877A as a slave device of the I2C interface. After writing the program and burning it, I found that the clock at the SCL end could not be input. After a period of time, when I in
old——Jia Microchip MCU
dsp28335 AD sampling single mode
[p=28, null, left][color=rgb(69, 69, 69)]Three modes are configured: single mode, continuous mode and DMA transfer[/color][/p][p=28, null, left][color=rgb(69, 69, 69)]Single mode calls the acquisition
fish001 DSP and ARM Processors
How to use circuit to stabilize signal?
I want to stabilize the signal output by the low-frequency power amplifier without using a task chip. Can I use some simple components to stabilize the signal? Please give me some advice! Thank you in
jackiesh Embedded System
XTR111 4-20mA circuit problem
As shown in the figure below, the official 4-20mA schematic diagram is imitated. Since the microcontroller does not have DA, DAC7512 is used. During the debugging process, it is found that the 5V outp
zixialong Analogue and Mixed Signal
Purgatory Legends - Battle of Relational Operators
[align=left]There are four types of relational operators: [/align][align=left](1) a b a is greater than b [/align][align=left](3) a=ba is less than or equal to b [/align][align=left](4) a=ba is greate
梦翼师兄 FPGA/CPLD
Please teach me how to set the high frequency crystal oscillator of msp430F5438
Has anyone used XT2? The registers of 5xx series are quite different from the previous ones. I can't set XT2 as MCLK. The clock register settings are as follows:P5SEL=0x0C; //crystal high ON P5.2.P5.3
lxcqh2008 Microcontroller MCU

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号