Training

Location:Training / Embedded Development / Getting Started with GD32 Embedded Development / SPI hardware peripheral principle of GD32F10x

You can log in to your eeworld account to continue watching：
SPI hardware peripheral principle of GD32F10x
Login

Duration：20 minutes and 7 seconds
Date：2023/09/15

Uploader：桂花蒸

Introduction

keywords： GD32

Getting Started with GD32 Embedded Development - Hand Typing Code

You Might Like

Recommended Posts

Can you imagine what it would look like if the 50K ATmega16 disassembled boards were put together?: [img]http://www.ouravr.com/bbs/bbs_upload88916/files_10/ourdev_302696.jpg[/img] [img]http://www.ouravr.com/bbs/bbs_upload88916/files_10/ourdev_302697.jpg[/ img] [img]http://www.ouravr.com/bbs/bbs_uplo; wangzujin38 Microchip MCU

What are the advantages of HK7833 compared to ASM1117-3.3V? Why does the former cost 1 yuan, while the latter only costs 0.1 yuan?: Comparing the two voltage regulators, both are linear regulators, and the AMS1117 can output a maximum current of 1A, while the HK7833 can only output a maximum current of 500ma, but the price is 10 t; 赵怡彬 Power technology

Based on AM335X development board ARM Cortex-A8——NAND FLASH version core board usage instructions: Preface: The usage of the NAND FLASH version and the eMMC version of the core board are basically the same. This article mainly describes the U-Boot compilation, basic device tree file compilation, NA; 别打牛牛 ARM Technology

I don't understand many formulas, and my head is buzzing.: How is the formula for the red line calculated? Why is the result 5.62A? I can't get this result no matter how I calculate it.; sky999 PCB Design

Continued from the previous post - MAGTROL HD-106-8NA-0100 dynamometer failure: The figure shows the fault display phenomenon of the control display DSP6001 of the MAGTROL HD-106-8NA-0100 dynamometer, which is over-range. The maximum range of the machine is 18mNm (about 183.78g.c; UUC Industrial Control Electronics

Why does the keilc debugger jump to a sub-function that has not been called when running the main function?: Why does the keilc debugger jump to a sub-function that has not been called when running the main function? After putting that sub-function in the main function, the main function will run to a part a; 一脸懵逼 MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号