Training

Location:Training / Computer and Programming / Programming / Embedded Qt5 C++ development / Qt serial port programming-(1) PC interface design

You can log in to your eeworld account to continue watching：
Qt serial port programming-(1) PC interface design
Login

Duration：22 minutes and 33 seconds
Date：2023/04/17

Uploader：EE大学堂

Introduction

keywords： Embedded Punctual Atom C++ QT5

This course is the embedded Qt5 C++ development course in the series of courses taught by Punctual Atom to teach you step by step on Linux. The supporting development board of this course is the Punctual Atom I.MX6/STM32MP157 development board.

You Might Like

Recommended Posts

Automotive RFCMOS 77GHz Radar Module Design: This design is a solution for 76GHz to 81GHz radar sensor modules. The onboard power supply converts the car battery input to the power rails required for the radar AFE, processor, and CAN-FD transcei; Jacktang Wireless Connectivity

Help: Puyuan DS5102CA waveform measurement problem: I bought a Puyuan DS5102CA oscilloscope ten years ago. Suddenly, no matter what waveform I measure, as long as there is a signal, it is a 50HZ sine wave. However, the 1KHZ 1V signal that comes with th; bigbat Analog electronics

What is PIC microcontroller: PIC ( Peripheral Interface Controller ) is an integrated circuit ( IC ) used to control peripheral devices . It is a CPU with decentralized (multi-tasking) functions . Compared with humans, the brain; rain Microchip MCU

Layout requirements for power amplifier boards: I'm drawing an amplifier board recently, and the board thickness is 1mm, and the trace is 0.508. However, since the power of the amplifier chip is 30W and the requirement is 20W, I don't know if this; dandanyuan PCB Design

Introduce TI's TCP/IP protocol stack--NDK: This is the network protocol stack used in the video encoder with TI's DM642. The source code is available for download on TI's official website. There are also some technical documents about NDK on W; Jacktang DSP and ARM Processors

What is a push-pull power amplifier?: Using two transistors with the same characteristics, make them both work in Class B state, one of which works in the positive half cycle and the other in the negative half cycle, and then try to combi; Jacktang Analogue and Mixed Signal

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号