Training

Location:Training / Circuit Fundamentals / Digital / Learn how computers perform logical operations in one lesson / Learn how computers perform logical operations in one lesson

Chapter 1：Learn how computers perform logical operations in one lesson

Duration：14 minutes and 25 seconds
Date：2015/09/15

Uploader：chenyy

Introduction

keywords： microprocessor transistor logic operation computer

Look inside the computer, how the transistors in the microprocessor work together, and how logic gates are used to perform operations.

You Might Like

Recommended Posts

Could you please tell me how to control the charging of lead-acid batteries using a single-chip microcomputer?: [backcolor=rgb(238, 238, 238)][font=Tahoma, Helvetica, SimSun, sans-serif][size=24px]How to design the software to charge the lead-acid battery without using a dedicated battery power management IC an; stm32f103vct6 Power technology

I developed an application software using wince4.2 EVC4.0, and an exception occurred. Please give me some advice.: The specific phenomenon is: A pop-up window: There is a problem in line 344 of map_pp.cpp; Ignore, Retry, Cancel the selection to retry, and the window closes; Close the application, and a pop-up wind; xzl08 Embedded System

Moderator, how to adjust the conflict between the basic timing 1ms and writing EEPROM?: Moderator, how to adjust the conflict between the basic timing 1ms and writing EEPROM?; hyforwin stm32/stm8

About capturing data and UART: The beginner is using MSP430G2553. After reading the information on the forum, I learned about UART transmission and the use of timer to capture data. If there is pulse input data, can it be possible; w765432001 Microcontroller MCU

Last day, 74% winning rate: Watch the video "Avoiding Common AC-DC Design Pitfalls" and win a prize: Netizens who haven't participated yet are welcome to participate as soon as possible. The prizes haven't been drawn yet, and I'm really worried~Event time : From now until March 16 How to participate; nmg Power technology

2407 interrupt, LACC PIVR, why does 1 need to be shifted left?: Why must the interrupt address be "left-shifted" by one bit to the PIVR content before adding the base address? Why is it necessary to shift left?LACC PIVR,1; Read the peripheral interrupt vector regi; netflu Microcontroller MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号