• You can log in to your eeworld account to continue watching:
  • Digital speed measurement, digital PI regulator design, digital DC speed control system examples
  • Login
  • Duration:42 minutes and 18 seconds
  • Date:2022/01/24
  • Uploader:Lemontree
Introduction
Automatic control system Yu Fashan, Henan University of Science and Technology
Unfold ↓

You Might Like

Recommended Posts

How to correct the scale of glass rotor flowmeter when in use
Glass rotor flowmeter is an instantaneous flow measurement instrument that is simple to use, easy to read, and widely used. It is extremely important to choose and use this instrument well. Regarding
cfybhd Sensor
New Driving Force MM32F103 Test (VII) DAC Output
[size=3] There is a DAC output experiment in the official routine. This experiment uses the DAC output (PA4) function of the MM32F103 development board to drive the D2 light-emitting LED to simulate t
lising Motor Drive Control(Motor Control)
msp430 button control LED light
#include "io430.h"/*There are two ways to control the on and off of the LED light.Method 1: interrupt function. Method 2: use if(P4INBIT2) to judge.When writing code, try to follow the steps to avoid
fish001 Microcontroller MCU
MATLAB simulation model for online parameter identification of permanent magnet synchronous motor based on MRAS
The MATLAB simulation model for online parameter identification of permanent magnet synchronous motor based on model reference adaptive MRAS can identify the motor resistance, inductance and permanent
alphaalgorithm Motor Drive Control(Motor Control)
It is said that noise spectral density is more useful than signal-to-noise ratio?
The following article is from Analog Devices, author ADIHave you noticed that when comparing systems operating at different speeds, or looking at how a software-defined system handles signals of diffe
btty038 RF/Wirelessly
I am designing a transformer for a flyback switching power supply. Is my estimate of the maximum duty cycle correct?
I first determined the range of the turns ratio (0.3, the maximum input voltage is the drain peak voltage) based on the maximum withstand voltage of the primary-side MOS tube and the reverse withstand
西里古1992 Analog electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号