There is no power display on my wince 5.0 development board. How can I implement it? It's so troublesome. I checked some information, but I still have no idea. It says that hardware support is needed,
CAN rate conversion is a common application. For example, to connect a 250Kpbs CAN bus to a 500Kbps bus so that the data can be communicated, rate conversion is required. As shown in the following fig
When using an oscilloscope probe to measure the AC waveform between the two ends of a component, if the peak value of the AC voltage of the probe ground wire is 180V and the minimum value is -180V, th
My gprs module is sim300, and I use command mode to establish a TCP connection. The received data will be directly transmitted from the serial port to the computer. Now I have a question, if an at com
[i=s]This post was last edited by dsjsjf on 2019-3-1 11:15[/i] [url=https://en.eeworld.com/bbs/elecplay/content/103]The development board ST NUCLEO-H743ZI evaluated in this event is provided by STMicr