The course aims to explain how MOS transistors work and how to model them. The knowledge provided in this course is essential not only for device modelers, but also for designers of high-performance circuits.
An error occurred during the installation of WINCE4.2. The error message is as follows: Error 21337. Setup encountered problems installing some critical emulation components. You may continue the inst
It is not right to not learn HDL language after getting an FPGA board. I looked at the Verilog tutorial and felt that it was too empty to just read it. I might as well do something. So I decided to ma
The IO ports of STM32 can be configured into 8 modes by software: 1. Input floating 2. Input pull-up 3. Input pull-down 4. Analog input 5. Open-drain output 6. Push-pull output 7. Push-pull multiplexi
I want to know how to implement the arbitration code in the command of the sdram controller code segment? The code segment is as follows:
// set command_delay shift register and command_done flag // T
As the title says! If you have done this, please give me some advice. When I was working on AM335X, I found that the GPMC_CLK pin of its GPMC bus interface only outputs a clock when the interface is o
I have been working as a C++ engineer for several years and have always been interested in low-level development and hardware. I would like to develop in the direction of architecture and plan to do m