Training

Location:Training / Embedded Development / MCU / Getting Started with MSP430 LaunchPad / Getting Started with MSP430 LaunchPad

Chapter 1：Getting Started with MSP430 LaunchPad

Duration：18 minutes and 6 seconds
Date：2013/01/01

Uploader：EE资深网友

Introduction

keywords： MSP430 OF C2000 MCU

The Getting Started with the MSP430 LaunchPad Workshop is an in-depth introduction into MSP430 basics. The LaunchPad is an easy-to-use development tool intended for beginners and experienced users alike for creating microcontroller-based applications.

The LaunchPad development kit is a part of the MSP430 Value Line series. LaunchPad has an integrated DIP target socket that supports up to 20 pins, allowing MSP430 Value Line devices to be dropped into the LaunchPad board.

Also, an on-board flash emulation tool allows direct interface to a PC for easy programming, debugging, and evaluation. Included are free and downloadable software development environments for writing and debugging software.

LaunchPad can be used to create interactive solutions thanks to its on-board push buttons, LEDs, and extra input/output pins for easy integration of external devices.

You Might Like

Recommended Posts

The Raspberry Pi discount quota is full. Check out other e-selected products to participate in the event: Recently, the products in e-Mall's "e-Select" magazine have been jointly organized by the forum. If you buy the products mentioned in the magazine, you can get a reward of 50 or 100 yuan. The quantity; nmg Embedded System

【Video】DIY process of wireless remote control handle based on 51 single chip microcomputer: :)[font=微软雅黑][size=4][color=#ff0000]First of all, I wish you all a happy Chinese New Year[/color][/size][/font]:)[font=微软雅黑][size=4] I recently recorded a DIY video of a wireless remote control handle; @ZiShi DIY/Open Source Hardware

Go your own way and let the SI engineer decide: SI engineer: "You may need to change all the routing for this part."I didn't expect to get this answer from the SI engineer: "No, I'm serious."A few short sentences can actually mean a lot. They not o; yvonneGan PCB Design

Op amp bias problem caused by pre-stage RC filtering during weak signal detection: Recently, I was working on a problem of using a copper-clad board as a handwriting board. I needed to detect extremely weak signals (0.2mV and above). Because there was a lot of noise, I used a filter; 扶摇- Analog electronics

Wince 6.0 restart or reset problem..: I have a question about the restart of wince 6.0, please help me... According to the Internet, restart (hot start) calls the IOCTL_HAL_REBOOT function of the OAL layer to restart or call SetSystemPowe; dingedward Embedded System

Help: I used 3843 to make a flyback switching power supply (input 220V, output 24V/100W, feedback package 18V), the frequency is 40KHZ, but as soon as the power is turned on, 3843, mos, and C14 are damaged; zgbpower Power technology

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号