Training

Location:Training / Embedded Development / MCU / Atmel|SMART MCU based on Cortex M0+ core / Atmel|SMART MCU based on Cortex M0+ core

Chapter 1：Atmel|SMART MCU based on Cortex M0+ core

Duration：26 minutes and 42 seconds
Date：2014/11/24

Uploader：dongcuipin

Introduction

keywords： Atmel CortexM0+ MCU

The microcontroller (MCU) series based on Atmel|SMART SAM D ARM Cortex-M0+ embodies Atmel's decades of innovative ideas and rich experience in embedded flash microcontroller technology. It not only sets new benchmarks in flexibility and ease of use, but also combines the high performance and efficiency of ARM Cortex-M0+ based MCUs with an optimized architecture and peripheral set. Atmel|SMART SAM D brings you a truly distinctive general-purpose microcontroller ideal for many low-power, cost-sensitive enterprise and consumer applications

You Might Like

Recommended Posts

A circuit that converts positive 5V to positive and negative 5V. Can anyone explain the principle to me? Thank you: [size=5][font=Tahoma, Helvetica, SimSun, sans-serif][font=Tahoma,]I know that the left side of the circuit above is oscillating to generate AC power, which is coupled to the right side through a trans; 6688hyc Analog electronics

[Repost] Useful information: One article teaches you how to understand inductors: [align=left][color=rgb(25, 25, 25)][font="]An inductor is a component that can convert electrical energy into magnetic energy and store it. It has the characteristics of preventing alternating current; 皇华Ameya360 Power technology

Research and Design of SDTVHDTV Conversion Based on FPGA: 至芯科技FPGA大牛 FPGA/CPLD

What does this addition and subtraction circuit do here?: The input waveform in front of C44 is a sine wave of about tens to hundreds of mV. After being amplified by the first op amp, it enters the second op amp U7B, where it is still amplified and then conv; 天天1 Analog electronics

Why is NEXT grayed out when I open the example?: Why when I open the example, which NEXT is grayed out? I opened it before and it was not like this.I found that some of them are grayed out, and some are not.; 陈纬 NXP MCU

Double-sided copper clad: Why are both the top copper and bottom copper connected to GND in a double-sided board? Can't one layer be connected to GND and the other layer to VCC? ? ?; blm1991k PCB Design

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号