The Type-C female socket I bought has not arrived yet, and I am in a hurry to make a board. Can you help me check if the 5V and ground pins are connected correctly?
Hello everyone:When I install a software, I need to use the make command to compile the makefile in it before the installation is successful. However, I have installed the MinGW software and replaced
[backcolor=rgb(239, 245, 249)]In the reference manual, there is a section on the RCC chapter, which says that the frequency of the external/internal clock can be measured through channel 1 of TIM16. [
In the program, duty is the parameter for controlling the duty cycle; count is the parameter for controlling the frequency division. By changing the two parameters of duty and count, a clock signal wi