Training

Location:Training / Embedded Development / Punctual Atomic teaches you step by step how to learn STM32-STemWin / BUTTON and BUTTON bitmap display

You can log in to your eeworld account to continue watching：
BUTTON and BUTTON bitmap display
Login

Duration：45 minutes and 8 seconds
Date：2019/02/24

Uploader：JFET

Introduction

keywords： graphic interface Punctual Atom emWin

This video uses the Zhengdian Atom development board as the platform. It will lead everyone to learn the various functions of the STemWin graphical interface from the simple to the deep, start a new STemWin journey for you, and explain the transplantation of STemWin and the use of various controls.

You Might Like

Recommended Posts

The use of microcontrollers: The use of microcontrollers; fangmeilian MCU

A design of reflective memory card system based on PCI bus: [align=left]1 Introduction For real-time transmission, the traditional Ethernet network is difficult to meet the requirements of real-time network due to the uncertainty of transmission protocol overh; trueleven Industrial Control Electronics

In the MOS tube switch circuit, the gate has a resistor and a diode connected in parallel. What are they used for?: As shown in the figure, I saw these usages in some datasheets. After looking up the information myself, there is a saying that it speeds up the MOS tube segment. I would like to ask the seniors to hel; lllxxq141592654 Analog electronics

Read the good book "Operational Amplifier Parameter Analysis and LTspice Application Simulation" 02 What is the definition of positive feedback and negative feedback of operational amplifier?: When I saw this passage while studying, it seemed different from what I learned in school. What do you think?When I was in school, I used a book on analog electronics written by Professor Hua Chengyin; nemo1991 Analog electronics

06. Anlu SparkRoad domestic FPGA evaluation [Learning] RGB lights: [i=s]This post was last edited by 1nnocent on 2022-7-27 15:44[/i]The function implemented by the RGB three-color lamp routine is to light up the three colors R, G, and B alternately. I would like to s; 1nnocent Domestic Chip Exchange

STM32 microcontroller thanks: [i=s]This post was last edited by ddllxxrr on 2021-1-28 12:24[/i]This is how the matter originated. My company wants to modify a solution, so I will do it. I still use the old MCU STM32F100C8T6. Since; ddllxxrr stm32/stm8

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号