Training

Location:Training / Hot Applications / Industrial Control / robust control theory / Norms of signals and systems (2)

You can log in to your eeworld account to continue watching：
Norms of signals and systems (2)
Login

Duration：18 minutes and 10 seconds
Date：2018/11/27

Uploader：老白菜

Introduction

keywords： control Uncertainty Robust control Singular system

This series introduces the norms of signals and systems, basic concepts, uncertainty and robustness, parameterization and simultaneous stabilization, basics of time domain mathematics, robust control of uncertain linear systems, control, robust control of singular systems , Robust control of uncertain time-delay systems and other nine topics.

You Might Like

Recommended Posts

ERROR: Power Handler function yield to low priority thread.: My machine cannot be woken up during the suspend==>resume process. The serial port information is: BSPPowerOn PCF: HW_PowerUp Backlight SET OK! :: BACKLIGHT ON ! [HSMMC0] Power Up the HSMMC Host Contr; echoyang Embedded System

Introduction to TI battery failure modes and BMS related solutions: First, let’s take a look at the battery failure modes. Why do batteries fail? 1. Battery aging – internal resistance and capacity[align=center][/align] [align=left] 2. Battery cell related issues[/ali; alan000345 Analogue and Mixed Signal

ucGUI problem help (12 DROPDOWN controls defined cannot be displayed): /* ****************************************************************** **uCGUIBuilder** **Version:4.0.0.0** **2012 / 04** **CpoyRight to: wyl** **Email:ucguibuilder@163.com** **This text was Created by; shkhlove Real-time operating system RTOS

I played with the 3D printer sent by cardin6 for two days.: [i=s]This post was last edited by wugx on 2016-10-7 21:02[/i] A batch of printer parts arrived from July to October. I installed them these two days and found that the design of this printer is simple; wugx MicroPython Open Source section

Two small circuit design mistakes: [p=24, null, left][color=rgb(73, 73, 73)][font=微软雅黑]Today I will write about two circuit design errors. The first one is caused by insufficient current gain. This circuit is based on the design of oth; eeskill Analog electronics

485 communication encountered strange problems!: When I was doing 485 communication between PC and 51 MCU, I used three wires to connect, A, B and GND, and used 232-485 converter on PC side, and ran Serial Port Wizard. During communication, MCU firs; longxin Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号