Training

Location:Training / Maker Show / Arduino / Arduino Creative Design Set: Hardware Design Brainstorming / Arduino controls the six-axis CNC manipulator model to simulate the welding process

You can log in to your eeworld account to continue watching：
Arduino controls the six-axis CNC manipulator model to simulate the welding process
Login

Duration：22 seconds
Date：2015/04/17

Uploader：chenyy

Introduction

keywords： Arduino Maker robot hardware design

I built a voice-controlled wall-e automatic robot using Arduino, and it even recognized the Spanish accent. There is an exploration mode and an autonomous mode that use its own sensors to avoid obstacles and search for a space where it can move and dance.

You Might Like

Recommended Posts

The serial UART of DSP 5502 uses DMA to transfer data, 16 bytes at a time: [color=#555555][font="][size=14px]The serial port UART of DSP 5502 uses DMA to transfer data, 16 bytes at a time, and any bytes exceeding 16 bytes will be lost. Is there something wrong with my config; 光亮自在 DSP and ARM Processors

bq76930 error in reading temperature value: bq76930 error in reading temperature value Most of the time, the current, voltage and temperature are normal, but from time to time the temperature will be read as very high, higher than 100 degrees,; lin196@21cn.com Analogue and Mixed Signal

EEWORLD University Hall----Live Replay: Detailed Explanation of Ultra-Low Power RSL10 Bluetooth SoC Development Board: Live replay: Detailed explanation of ultra-low power RSL10 Bluetooth SoC development board : https://training.eeworld.com.cn/course/6056; hi5 Integrated technical exchanges

Is the larger the UPS power factor, the better?: For a long time, the issue of UPS power factor has been a focus of debate for both UPS suppliers and users : users claim to want UPS with a high power factor, and suppliers also say that the higher th; frozenviolet MCU

Share the problem and solution of using TB to capture pulse width of MSP430: Hardware: MCU: MSP430F149Crystal: 32K, 8MInput signal: 10ms low level, 7.5ms high level received via wireless,Input port: P4.0 (TB0)Requirement: Capture the pulse width of the low level Software:1. In; 火辣西米秀 Microcontroller MCU

When using CPLD to decode AES/EBU audio, the decoded data has spike pulses. What is the reason?: I used CPLD to make an AES/EBU audio decoder. I used a 50MHZ crystal oscillator as a counter to count. I decoded the data stream based on the counter size. I used a sine wave as the source. The peak-t; XCXBD EE_FPGA Learning Park

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号