Hello everyone, I have a project to make a parking heater, but I don’t know how to control the oil pump and motor control method. Please give me some advice if you have done such a project. Thank you
As shown in the picture, the PCB board I designed uses some pads. What I hope to achieve is to cover the pads at the bottom of the pad with oil (to prevent short circuit with the matching metal parts)
Can someone tell me the program... 2812 and AD7928... What does it mean... /* //Read ADC conversion result: AdcValueInt[0]=AdcOpr(0x8330); //Set channel 0 AdcValueInt[0]=AdcOpr(0x8730); //Read channel
Finally, it can be disassembled. Here are the pictures.
Open the battery cover and you can see a little glue, which will be introduced later.For the power connection, two batteries are connected in se
[b]Abstract[/b]: UART is a widely used serial data communication circuit. This design includes a UART transmitter, receiver and baud rate generator. The design applies EDA technology to design and imp
The APD-130TC7-7F in the figure is a photodiode. Theoretically, a photodiode should generate a current signal when exposed to light. According to the theoretical knowledge of operational amplifiers, t