Training

Location:Training / Power Supply / DC power supply design / Linear DC power conversion (Linear Regulator, LDO)

You can log in to your eeworld account to continue watching：
Linear DC power conversion (Linear Regulator, LDO)
Login

Duration：6 minutes and 12 seconds
Date：2018/02/21

Uploader：老白菜

Introduction

keywords： Power supply filtering BUCK

DC Power Filter (DC power filter)
DC power filter is the basis that affects the entire hardware circuit.
Course objectives:
Understand the "action principle, impact on system quality, combination type, material selection principles, and layout specifications" of DC power filters.

Linear DC power conversion (Linear Regulator, LDO)
course objectives:
1.) How to determine "switching type" Or "linear" DC power conversion architecture
2.) Understand the categories and advantages and disadvantages of "linear DC power conversion"
3.) Understand the impact of "linear DC power conversion" on system quality
4.) Understand "linear DC power conversion" "Matching with "MLCC"
5.) Understand the material selection principles under "Linear DC Power Conversion"
6.) Understand the Layout specifications of "Linear DC Power Conversion"

You Might Like

Recommended Posts

The problem of PCB parasitic capacitance: [i=s] This post was last edited by S3S4S5S6 on 2017-11-9 08:48 [/i] An oscillation circuit was built using TLV3501 according to the typical application in the manual. After PCB layout, it was found th; S3S4S5S6 PCB Design

Why can the reference layer of PCB also be the power layer?: As shown in the figure above, in a 4-layer PCB stack, why can the differential line refer to the third layer (Power layer)? I understand that ordinary single-ended signals must be referenced to the gr; xiaominwzj PCB Design

I drew the schematic using protues software, and after converting it into a PCB diagram, I found that only the buzzer was not packaged.: I finished drawing the schematic diagram using protues software. After converting it into PCB diagram, I found that only the buzzer was not packaged. After checking online, I found that I had to draw; 圈在指尖 PCB Design

Questions about SPI in 5438: The direction of the signal on the middle line is from slave to master. Does it mean that the slave controls the UCxSTE bit of the master? But I think it should be manually decided in the program whet; zzbaizhi Microcontroller MCU

Basic knowledge of automobile body design: This article provides some basic knowledge of automobile body design, which is suitable for learning and training of relevant departments in the automobile industry. Main contents: Main components of; frozenviolet Automotive Electronics

Please help me read the next program, which is to clear the RAM from 0200H to 05FFH! Is it correct?: Please help me look at the next program, which is to clear the RAM from 0200H to 05FFH!Is this correct? Because it feels like it should be written. Shouldn't Address be +2 each time?unsigned int *ptr;; 零晨 Microcontroller MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号