• Duration:7 minutes and 25 seconds
  • Date:2015/04/16
  • Uploader:chenyy
Introduction
keywords: Arduino Maker RS
    RS Components presents you a series of ten videos (Chinese subtitles) to help you learn to use the Arduino starter kit. In this video, we will learn the basics of using the Arduino starter kit.
    Arduino is an open source electronic prototyping platform based on flexible and easy-to-use hardware and software development. It's also a great starter kit for users to experiment, learn, and master the basics of electronic engineering.
    Massimo Banzi is one of the founders of Arduino. Starting from the beginning of October 2012, for ten consecutive weeks, RS will launch a course produced by Massimo every week to let you learn to use Arduino. Allowing you to unleash your creativity and build your own electronic gadgets!

Unfold ↓

You Might Like

Recommended Posts

Unable to connect USB device
I have done a USB project before, and it was relatively stable. Later, I made a different board. The chips are the same, both are STM32F103C8T6. I modified the code slightly and burned it into the boa
chenbingjy stm32/stm8
[Project source code] Determine the correspondence between the dedicated clock input pin of the FPGA and the PLL
This article and design code were written by FPGA enthusiast Xiao Meige. Without the author's permission, this article is only allowed to be copied and reproduced on online forums, and the original au
小梅哥 Altera SoC
Use and maintenance of automobile ABS system 2
4. When inspecting the wheel speed sensor, be careful not to damage the gear ring teeth and the sensor head. Do not use the gear ring as a fulcrum to pry. Otherwise, the gear teeth will be deformed, r
frozenviolet Automotive Electronics
TI Carnival + Simple Product Shopping Experience
I have bought things in TIstore more than once or twice. Generally speaking, it has been quite smooth. Just click on the activity link. Click Buy directly to add it to the shopping cart, just like Tao
jishuaihu Wireless Connectivity
MCU + I2C communication response signal is abnormal
Use Proteus to simulate the I2C communication between 89C52 and 24C02, and read the data written into 24C02 to light up the LED controlled by P1; it is found that the LED light in Proteus cannot light
elec32156 51mcu
Problems with microcontroller IO port controlling relays
The schematic diagram is as above. The voltage level at RELAY1 varies, and the right end of R54 is always more than 4V. Can an expert tell me where the problem is? Thank you!
chenbingjy Analog electronics

Recommended Content

Hot VideosMore

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号