STM8 MCU STVD environment monitors multiple elements of array variables-EEWORLD

Collect

To monitor multiple elements of an array variable during debugging, modify the following settings

Keywords：STM8 Reference address：STM8 MCU STVD environment monitors multiple elements of array variables

Previous article：The correct waveform of STM8L152C6T6 operating M24LR64 through IIC interface
Next article：How to generate HEX file or BIN file from IAR platform project

Recommended ReadingLatest update time:2024-11-25 13:46

51 MCU Registers-3.1 MCU Timer

Earlier, we explained how to delay the time by software, thereby increasing the interval between the light on and off. The process is to let the CPU do other things, so as to achieve the delay effect. However, software delay is not very accurate. Here we will learn a more accurate hardware delay, also called a timer. H

[Microcontroller]

Introduction to the principle of controlling a multi-purpose electronic clock based on PIC16C55 single-chip microcomputer

This electronic clock is controlled by PIC16C55 single-chip microcomputer , which is suitable for timing constant temperature of greenhouse or timing constant pressure control of tap water. The operating voltage of PIC16C55 single-chip microcomputer is 2.5～6.25V, with low power consumption and strong driving ability.

[Microcontroller]

Introduction to the principle of controlling a multi-purpose electronic clock based on PIC16C55 single-chip microcomputer

51 MCU analog-to-digital conversion A/D and digital-to-analog conversion D/A

1. (Concept) A/D is the conversion from analog to digital, relying on the analog to digital converter (ADC). D/A is the conversion from digital to analog, relying on the digital to analog converter (DAC). It is called DAC. 2. Number of ADC bits: An n-bit ADC means that the ADC has 2 to the power of n scales. An 8-bit

[Microcontroller]

MCU IIC bus protocol and detailed routines

Let's first briefly explain the I2C bus. The I2C bus is a serial data bus with only two signal lines, one is the bidirectional data line SDA, and the other is the clock line SCL. The communication between the processor and the chip can be figuratively compared to two people talking: 1. The other person must be able t

[Microcontroller]

STC15 MCU ADC thermistor temperature measurement source program

Pinno Electronics STC15W4K-Experiment 29-ADC Thermistor Measuring Temperature The microcontroller source program is as follows: /************************************************************************************ * * Experimental platform: Pivot Electronics STC15W4K core board + Pivot Electronics "Pioneer" expansi

[Microcontroller]

Method of 51 MCU external expansion ROM memory

　　It is strongly recommended that users do not consider external expansion of program memory as much as possible. If expansion is necessary, it can be expanded by imitating the circuit shown in the figure below. 　　In the figure, port P0 outputs the low 8-bit address signal of the external ROM, and port P2 outputs

[Microcontroller]

Method of 51 MCU external expansion ROM memory

Chapter 8 MCU System Expansion Design

System interface expansion technology Memory expansion technology Input/output (I/O) and interrupt expansion technology Basic Methods of Parallel Interface of MCS-51 Single Chip Microcomputer The interface design between the microcontroller and the external parallel device has two tasks: hardware

[Microcontroller]

"Power failure" cannot be ignored. The single-chip microcomputer system provides conditions for circuit protection

Usually, in single-chip computer systems such as digital clocks, bell ringers, some timers and calendar clocks , when the main power supply DC5V is lost, we call it power failure. After power failure, the single-chip computer will stop working and the clock will stop moving forward. This result is often undesirable in

[Power Management]

Popular Resources
Popular amplifiers

Latest Microcontroller Articles

Naxin Micro and Xinxian jointly launched the NS800RT series of real-time control MCUs
On November 20, Naxin Micro announced that it would launch the NS800RT series of real-time control MCUs in cooperation with ChipSine. This series of MCUs has more efficient and powerful real-time control capabilities and rich ...
How to learn embedded systems based on ARM platform
1. The concept of embedded system focuses on understanding the concept of "embedded" from three aspects: 1. From the hardware perspective, the CPU-based peripheral devices are integrated into the CPU chip, such as the early X86-based ...
Summary of jffs2_scan_eraseblock issues
Summarize the problems encountered before: 1 Similar: mtd->read(0x44 bytes from 0x68cf44) returned ECC errorjffs2_get_inode_nodes(): CRC failed ...
Application of SPCOMM Control in Serial Communication of Delphi7.0
Abstract: Using Delphi to develop industrial control system software has become the choice of more and more developers, and serial port communication is one of the problems that must be solved in this process. ...
Using TComm component to realize serial communication in Delphi environment
Abstract: Using Delphi to develop industrial control system software has become the choice of more and more developers, and serial port communication is one of the problems that must be solved in this process. ...
Bar chart code for embedded development practices
Embedded Development Learning (10)
Embedded Development Learning (8)
Embedded Development Learning (6)

He Limin Column Microcontroller and Embedded Systems Bible

Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.

MoreSelected Circuit Diagrams

Change More Related Popular Components

MorePopular Articles

MoreDaily News

Guess you like