Very power-saving LED night light circuit-EEWORLD

Collect

16. Very energy-saving LED night light circuit.gif

Working principle of the circuit: The lighting power supply is directly powered by a 220 V AC power supply, and
a capacitor is used to limit the current. The VD6-VDs diode branch next to the white LED is used to protect
the surge voltage generated during the on and off period; VD6 blocks the reverse
voltage ; Rz is the discharge resistor of C; R1 is used
to prevent excessive current from being generated by burning C in case of a short circuit.

Keywords：LED Reference address：Very power-saving LED night light circuit

Previous article：Colorful flash LED light strip control circuit
Next article：Solar LED Street Light Solution Using STM32 MCU

Recommended ReadingLatest update time:2024-11-16 14:59

High performance LED driver power design

With the extensive use of high-power LED light sources, the technical requirements for LED drivers are increasing day by day. High-voltage and high-power LED drivers can be directly connected to the power grid (85V-265V). They can provide 100W of power. These drivers usually provide high current and high voltage output

[Power Management]

High performance LED driver power design

Power, protection and networking solutions for LED area lighting applications

High-intensity discharge lamps (HID) such as high-pressure sodium lamps (HPS) have the characteristics of high light intensity and long life, and are widely used in area lighting applications in public places such as street lighting, parking lots and parks. On the other hand, high-brightness white light-emitting diodes

[Power Management]

Power, protection and networking solutions for LED area lighting applications

Analysis of five key technical points related to heating and burning of MOS tubes in LED fluorescent lamp power supply design

　　 1. Chip heating 　　This content is mainly for high-voltage driver chips with built-in power modulators. If the current consumed by the chip is 2mA, and a voltage of 300V is applied to the chip, the power consumption of the chip is 0.6W, which will of course cause the chip to heat up. The maximum current of the dri

[Power Management]

Detailed explanation of the special uses of LEDs in different wavelengths

　　1.UV LED (Ultraviolet LED): 　　(1) Low UV: 250nm-265nm-285nm-365nm, and now it can reach 250nm-410nm. These are INGaN/GaN material carbides. These UV rays can kill all bacteria in the water, and their lethality can reach 98%, especially 285nm. 　　(2) Medium ultraviolet light: 365 nm -370 nm is used internationally

[Power Management]

PIC16f877A AD conversion LED display 8-bit value

Introduction: This article provides a PIC16f877A AD conversion LED display 8-bit value code. ;**************** list p=16f877A ; list directive to define processor #include p16f877A.inc ; processor specific variable definitions __CONFIG _CP_OFF & _WDT_OFF & _BODEN_OFF & _PWRTE_ON & _XT_OSC & _WRT_OFF & _LVP_OFF & _

[Microcontroller]

10W non-isolated LED driver solution based on TI control chip

This article introduces a 10W LED driver designed using TI control chip TPS92210 . TPS92210 has a unique critical mode fixed peak current control function, and the design does not require feedback, making the entire design simple, with fewer components and low cost. 　　In recent years, non-isolated solutions have bec

[Power Management]

10W non-isolated LED driver solution based on TI control chip

Efficiently drive LED offline lighting

In a streetlight application, a possible configuration is 80 LEDs in series to create a 300V/0.35A load. When choosing the power topology, the requirements for isolation and power factor correction (PFC) need to be determined. Isolation requires a lot of safety trade-off studies, including the need to provide electr

[Power Management]

Driving power supply: high reliability is the key to LED promotion

After the country issued the " 12th Five-Year Plan for Semiconductor Lighting Technology Development", the results of the "2012/2013 Semiconductor Lighting Product Financial Subsidy Promotion Project" led by the National Development and Reform Commission, the Ministry of Science and Technology, and the Mi

[Power Management]

Driving power supply: high reliability is the key to LED promotion

Popular Resources
Popular amplifiers