In the past half month, faced with the severe situation that my country's photovoltaic and other new energy industries have encountered trade barriers in major European and American markets, the National Energy Administration and other ministries and commissions have intensively introduced a number of policies to support photovoltaic, wind power and other new energy enterprises.
Starting tomorrow (November 1), the State Grid will provide free services for distributed photovoltaic power generation projects within the applicable scope, including system access plan formulation, grid connection testing, and commissioning. According to the "Opinions on Distributed Photovoltaic Power Generation Grid Connection Service Work" previously issued by the State Grid, the cost of connecting distributed photovoltaic projects with a voltage level of 10 kV or below to the grid and a total installed capacity of no more than 6 MW at a single grid connection point to the public grid will be funded by the grid companies.
At the same time, the Ministry of Finance, the National Development and Reform Commission, and the National Energy Administration issued the "Notice on the Subsidy Catalogue for Additional Subsidies for Renewable Energy Electricity Prices (Second Batch)" on the 29th. A total of 26 provinces and cities' wind power, solar energy, biomass energy, and wind-solar complementary projects were selected.
An official from the National Energy Administration recently told the media that the administration is planning to hold a national photovoltaic work conference to study industry development issues and supporting policies, including the "Guiding Opinions on Promoting the Development of my country's Photovoltaic Industry", the "Implementation Measures for Distributed Photovoltaic Power Generation Demonstration Zones and Electricity Price Subsidy Standards", etc.
As wind power and photovoltaic power generation are intermittent energy sources, their access has a certain impact on the stability of grid voltage, and the problem of absorption has always been the biggest obstacle to the development of new energy. Wang Sicheng, a researcher at the Energy Research Center of the National Development and Reform Commission, once said that the cost of connecting a photovoltaic grid to one access point is 420,000 yuan. For example, a 1 MW project requires more than 10 access points, and the access fee alone is more than 4 million yuan.
Shu Yinbiao, deputy general manager of State Grid Corporation of my country, said at a media briefing that the company has made major breakthroughs in grid construction, grid connection, market absorption, operation management, and standard formulation, which generally meet the needs of the rapid development of photovoltaic power generation in China. As of September this year, the grid-connected photovoltaic power generation capacity in the company's operating area was 2.71 million kilowatts, a year-on-year increase of 4.2 times; the power generation was 2.52 billion kilowatt-hours, a year-on-year increase of 5.4 times. my country has become one of the countries with the fastest growth in photovoltaic power generation installed capacity.
Previous article:How to select peripheral components of DC/DC converter IC
Next article:Bikini for MP3 charging 10 most weird charging inventions
- MathWorks and NXP Collaborate to Launch Model-Based Design Toolbox for Battery Management Systems
- STMicroelectronics' advanced galvanically isolated gate driver STGAP3S provides flexible protection for IGBTs and SiC MOSFETs
- New diaphragm-free solid-state lithium battery technology is launched: the distance between the positive and negative electrodes is less than 0.000001 meters
- [“Source” Observe the Autumn Series] Application and testing of the next generation of semiconductor gallium oxide device photodetectors
- 采用自主设计封装,绝缘电阻显著提高!ROHM开发出更高电压xEV系统的SiC肖特基势垒二极管
- Will GaN replace SiC? PI's disruptive 1700V InnoMux2 is here to demonstrate
- From Isolation to the Third and a Half Generation: Understanding Naxinwei's Gate Driver IC in One Article
- The appeal of 48 V technology: importance, benefits and key factors in system-level applications
- Important breakthrough in recycling of used lithium-ion batteries
- Innolux's intelligent steer-by-wire solution makes cars smarter and safer
- 8051 MCU - Parity Check
- How to efficiently balance the sensitivity of tactile sensing interfaces
- What should I do if the servo motor shakes? What causes the servo motor to shake quickly?
- 【Brushless Motor】Analysis of three-phase BLDC motor and sharing of two popular development boards
- Midea Industrial Technology's subsidiaries Clou Electronics and Hekang New Energy jointly appeared at the Munich Battery Energy Storage Exhibition and Solar Energy Exhibition
- Guoxin Sichen | Application of ferroelectric memory PB85RS2MC in power battery management, with a capacity of 2M
- Analysis of common faults of frequency converter
- In a head-on competition with Qualcomm, what kind of cockpit products has Intel come up with?
- Dalian Rongke's all-vanadium liquid flow battery energy storage equipment industrialization project has entered the sprint stage before production
- Allegro MicroSystems Introduces Advanced Magnetic and Inductive Position Sensing Solutions at Electronica 2024
- Car key in the left hand, liveness detection radar in the right hand, UWB is imperative for cars!
- After a decade of rapid development, domestic CIS has entered the market
- Aegis Dagger Battery + Thor EM-i Super Hybrid, Geely New Energy has thrown out two "king bombs"
- A brief discussion on functional safety - fault, error, and failure
- In the smart car 2.0 cycle, these core industry chains are facing major opportunities!
- The United States and Japan are developing new batteries. CATL faces challenges? How should China's new energy battery industry respond?
- Murata launches high-precision 6-axis inertial sensor for automobiles
- Ford patents pre-charge alarm to help save costs and respond to emergencies
- New real-time microcontroller system from Texas Instruments enables smarter processing in automotive and industrial applications
- Which sensors need to be potted?
- Why do we need to add DAC to the front end of the crystal oscillator?
- Getting Started with Modelsim
- Maintenance method of 18650 lithium battery pack
- 13.56Mhz read/write chip DS550's LPCD low power consumption card detection can be so simple and stable
- Use LGSR-WIFI serial port transparent transmission module as a remote external network online debugging tool to share
- Several considerations for DSP hardware design
- LTspice simulation tutorial——xutong
- How to choose crystal oscillator capacitor for RTC and microcontroller?
- [Exploration of RTOS and Linux controller cycloneDDS communication and encryption protection] Material unpacking STM32F7508-DK+ESP32 S3