5 ways to install LED light strips

① The four-wire LED light strip has four wires, three rows of lights (note that it is not four rows of lights~~), 24 lights per row per meter, 24*3=72. Since the power of each lamp bead is 0.05W, the power of the 72-bead LED light strip is: 72*0.05=3.6W.

② The width of the four-wire LED light is about 22mm, the thickness is about 8mm, and the weight is about 0.25kg/m (4 meters per kilogram)

③ Each LED light strip must be equipped with a special plug (plug with transformer); when connecting, be sure to remove the transparent plastic cover, connect the test light and then cover it. Do not connect directly with the cover, which is easy to short circuit!

④ Each meter has a "scissors" mark, and it can only be cut at the mark. If you cut it wrong or off-center, it will result in a meter of waste! Some will be off-center when marking, so it is best to carefully look at the position of the mark before cutting, and cut it at the place where there is no connection in the middle. You can see it if you look carefully.

⑤When installing the LED light strip, you can usually put it in the light trough and straighten it. You can also use a thin rope or thin wire to fix it. If you need to install it outside or vertically, you need to purchase clips and tail plugs separately. The original clips are fully transparent. It is best to apply waterproof glass glue on the tail plug and plug after installation, so that the waterproof performance is better.